Move to the view window, and add the elements to the model. To get used to the Revit flow, always remember these three steps: 1. FIGURE 1.21 Working with Revit starts with the ability to work with the view window, and learning the quirks and feel of the interface. The Revit World 16 FIGURE 1.20 How Revit Architecture works is evident in this procedure.You need to be com- fortable with this procedure (as much as possible). Do your walls look like Figure 1.21? If not, try it again. Move your cursor to the right and type 16, and hit Enter. Move your cursor straight down and type 16, and hit Enter. After you see this alignment line, and the temporary dimension says 100 ′–0″, pick this point. Notice that your temporary dimension says 100′–0″. Move your cursor to the right until you “run into” another blue alignment line. With the Wall command still running, move your cursor straight up from the endpoint of your 100 ′-long wall. The Revit Architecture Interface 15 FIGURE 1.19 The procedure for drawing a wall in Revit Architecture 4. The wall is now 100′ long (see Figure 1.19). (Notice you did not need to type the foot mark ( ′). Although dimensions cannot be typed over, this type of dimension is a temporary dimension for you to use as you place items. Also notice the blue dimension extending from the first point to the last point. In Revit, there is no “Ortho.” Revit will align the typical compass increments to 0, 90, 180, 270, and 45 degrees.
![revit 2011 requirements revit 2011 requirements](https://s1.manualzz.com/store/data/002758826_1-4187b8fc18bd881b69eaa8f7c1a1ed4c.png)
Notice that a two things happen: the wall seems to snap in a horizontal plane, and a blue dashed line apparently locks the horizontal position. With the first point picked, move your cursor to the left. With the Wall command still running and the correct wall type selected, position your cursor in a similar location to the illustration in Figure 1.19.
![revit 2011 requirements revit 2011 requirements](https://i.ebayimg.com/images/g/hWoAAOSwK7Ff~obC/s-l500.jpg)
Make sure that the wall is justified to the finish face exterior.) You may now proceed: 1. In the Properties dialog box, select Exterior - Brick and CMU on MTL.Stud. (If you have not been following along, you can start by clicking the Wall button on the Home tab. To continue placing some walls in the model, keep going with the exercise. The Revit World 14 FIGURE 1.18 The view window collects the results of your actions.